Project Showcase
Repair Of Basement Walls
PROJECT OVERVIEW:
1. We excavate a deep ditch around outside the damaged walls down passed the footer.
2. We take out the bad walls.
3. Replace footer if needed.
4. Drill holes in footer to put rebar every 32”.
5. Tooth in blocks to preexisting blocks.
6. Lay blocks and fill cores with concrete where the rebar is.
7. Parge, tar and put on waterproof barrier on replaced walls.
8. Put tile, stone and back fill in. Level area and put down grass seed.
But with this we stopped at the tar. The customer did the rest.
Basement Waterproofing
PROJECT OVERVIEW:
We offer the water proofing of basements.
1. Excavate a deep ditch around the outside perimeter of your home down pass the footer.
2. We power wash the exterior walls.
3. We then apply a coat of tar and then we parge the walls. After this is completed we use dimple board to stop water from entering the cement blocks.
4. Finally, we put down tile and stone. Then we back fill in ditch.
5. Level area and put down grass seed.
Parging Basement Walls
PROJECT OVERVIEW:
We offer parging of inside or outside basement walls with a smooth finish.
1. Clean the old foundation walls.
2. Screw wirer mesh to the foundation walls.
3. Then we parge with fiber mortar.
Installing a Bilco Door
PROJECT OVERVIEW:
We offer the the replacement of old Bilco Doors as well as the installation of new ones.
1. Remove old door
2. Check concrete and blocks off existing bilco door replace if needed.
3. Assemble new bilco door.
4. Seal around new door.
Veneer Stone
PROJECT OVERVIEW:
We are experts in veneer stone work.
1. Form a base with treated wood or concrete blocks.
2. Put on a vapor barrier.
3. Fasten wirer mesh to form or concrete blocks.
4. Then apply a scratch coat.
5. Apply veneer stone.